ipaq_101
Active Member
Update worked fine, no problem with 5ghz.
New Firmware Out
- Thread starter jkabaseball
- Start date
Update worked fine, no problem with 5ghz.
Problems here:
Surface Pro System Aggregator Firmware (v3.9.250.0) gives me an error in Device Manager (device cannot start) Tries to apply the update 3 times when re-booting, then goes to the cannot start error.
Also had to update the Life Cam Front driver manually.
The system aggregator seems to work if I roll it back to the previous version.
Surface Pro System Aggregator Firmware (v3.9.250.0) gives me an error in Device Manager (device cannot start) Tries to apply the update 3 times when re-booting, then goes to the cannot start error.
Also had to update the Life Cam Front driver manually.
The system aggregator seems to work if I roll it back to the previous version.
albertan_bear
Member
Same problem here.
kristalsoldier
Well-Known Member
Have any of you folks noticed an improvement in battery life after the firmware update? Thanks.
I didn't see anything indicating a battery life change and it would be a bit early to tell if there was. There were some changes for working with the battery cover unless they were for a new as yet unannounced SP3 battery cover.
kristalsoldier
Well-Known Member
Hmmm...Thanks. Unless I am being taken in by a sheer placebo effect, I get the impression that there is a marginal improvement in battery life. But, you are right, it is too early to tell.
graye
Member
On the previous firmware update, I had to manually apply them (using the instructions here: http://digitalmediaphile.com/index....tall-the-july-surface-pro-3-firmware-updates/)
I suspect that you could perform similar steps for the August update as well.
albertan_bear
Member
I did try to download and install it - it didn't work.
Similar threads
- Sticky
